Home
Home About Us Service Contact Us Order
Pressure Controllers
Time Controllers
Flow Measurement
Accessories
Plungers
Casing Plungers
Lubricators
Motor Valves
Flow Chokes
Sub-Surface Springs
Equipment Accessories
Vapor Recovery Unit
PumpMax Controller
PumpMax Motor
Field Services
Training
Troubleshooting
Build a Plunger
 


Float Choke

The Float Choke is a self-adjusting choke designed to keep the flow on the chart and measured.

The Multi Float Choke is ideal for a plunger lift system with velocity control problems. (This unique design was featured in an innovation in World Oil.)

When the tubing pressure has dropped close to the flow line or sales line pressure, the choke will spring open to pick up that flow rate and increase the plunger travel back to a more normal rate.

When the plunger arrives or is close to arrival, the tubing pressure will increase and the choke will return to the sales settings to keep the high pressure on the chart.

The Float Choke is adjustable for the setting of the high-pressure flow to keep it where needs to be on the meter. This setting is a variable based upon the orifice plate and the differential pressure of the tubing and line.

The Multi Float Choke comes in two sizes that can be determined by the volume of the well.

The 8201 Float Choke is a small unit that has a maximum of 5/8" when fully open. The flow direction is clearly marked on it and it must be connected as shown for the flow to operate the choke.

The 8602 Float Choke is a larger version that will permit the open flow rate to be about three times that of the smaller 8201. This unit can be flanged.

Shipping weight, about 18 lbs.

 

 

 



Float Choke