MAX III Series Pressure Controllers

The Max III is a full service differential pressure plunger lift controller with true tubing liquid level operation and exact duplication of procedures needed to keep a well performing. It is designed to prevent lost production due to excessive liquid loading.

The unit includes three pressure transducers that monitor the casing, tubing, and the flow line or gathering system pressure. The data obtained is used to adjust theplunger lift well to perform optimally under its existing conditions (i.e. The Max III adjusts to changing well conditions).

Liquid loading of the tubing and the well is a thing of the past. There is no lost production due to excessive liquid loading.

How Max III works …

1. The Max III opens the motor valve when the preset casing pressure is recorded by the controller.
   
2. The controller uses the difference between the casing and the tubing or tubing and line to determine the liquid level in the tubing.
   
3. The well will flow until the required difference set by the operator is recognized by the Max III and then close the motor valve.
   
4. The Max III is a fully automated, self-adjusting wellhead controller.
   
5. The Max III can literally flow the well for seconds, minutes, or hours after the plunger arrives, based on the monitoring of the liquid level.
   
6. If the level of liquid in the tubing is not at the designated column height, the well continues to flow.
   
7. No special programming or data entry is necessary to begin successful operation.
   

Shipping weight: 25 lbs