Build
a Plunger Lift System
Multi is your one-stop source for a complete Plunger Lift System,
which eliminates the need for a very costly pump jack.
Let’s build your system from the bottom up …
1. See Bottom Springs. Where the plunger’s
trip up begins, and the stopping point on the trip down.
Go
to Bottom Springs.
2. See Plunger. Uses gas pressure to lift water to the surface
where the water is drained off and gas flows to the gas line.
Go
to Plunger.
3. See Lubricator. The surface station for the Plunger; where
the water and gas lines are connected.
Go to Lubricator.
4. See Flow Choke. Regulates the pressure in the gas production system.
Go
to Flow Choke.
5. See Motor Valve. Opens and closes gas flow to the gas line.
Go to Motor Valve.
6. See Controller. The controller automates the system.
Go
to Controller.
7. See
Solar Panel. Charges controller batteries, extending battery life.
Go
to Solar Panel.
8. See
Sensor. The sensor signals the controller to activate
the cycle.
Go to Sensor.
Click here
to start again
